; bdiGDB configuration file for Cavium CN3010 (From CN3860)
; -------------------------------------------
;
; This configuration uses the monitor setup the board
;
[INIT]
;
; Invalidate Caches
IVIC                            ;Invalidate IC
IVDC                            ;Invalidate DC
WCP0    12  0x504000e5  ; status
WM64 0x8001180000000000 0x0000000080bf1f40 ;write to mio_breg_cfg0
WM64 0x8001180000000048 0x0004fc01441471c2 ;write to mio_breg_tim0

[TARGET]
; common parameters
POWERUP     2000                ;power-up delay 2 seconds
JTAGCLOCK   0                   ;use 16 MHz JTAG clock
;
;======================================================
; !!!! defines the cores numbers without any holes !!!!
;======================================================
;
; Core#0 parameters (active core after reset)
#0 CPUTYPE     CNMIPS           ;the used target CPU type
#0 ENDIAN      BIG              ;target is big endian
#0 JTAGDELAY   5                ;40 TCK's access delay
#0 STARTUP     HALT             ;STOP mode is used to let the monitor init the system
; #0 WORKSPACE   0xA0000080       ;workspace in target RAM for fast download
#0 BREAKMODE   HARD             ;SOFT or HARD
#0 SCANPRED    1   5            ; select 2nd device in scan chain
#0 SCANSUCC    0   0
;
;======================================================


[HOST]
IP               192.168.1.102

;#0  FILE        E:\temp\dump1024k.bin
;#0  FORMAT      BIN 0xA0020000
;#0  FILE        E:\cygwin\home\demo\mips64\fibo.x
;#0  FORMAT      ELF

#0  PROMPT      cnMIPS#0>


[FLASH]
; only to test execution of target code\
CHIPTYPE    MIRRORX8            ;Flash type (S29GL064)
CHIPSIZE    0x00400000          ;The size of one flash chip in bytes
BUSWIDTH    8                  ;The width of the flash memory bus in bits
;FILE        E:\temp\dump16k.bin
;FORMAT      BIN 0xA0300000


[REGS]
;used for all cores unless overridden
DMM1	0xFF300000      ;DSU base address
DMM2	0x8000000000000000    ;xkphys segment
FILE	$regCNMIPS.def